Articles & Guides

Installing a Swing Arm M20 Motor - Swing arm geometry part 1

In this video Mark discusses geometry when installing a Roger Technology M20 series swing arm motor.

All measurements when installing the M20 start from the gate pin in which the gate is hung, referencing the manual that is supplied with the M20 motor you will find all corresponding measurement as described in the video.

The ram that the motor is mounted to is welded to the gatepost and measurements are calculated from this point. The motors mount and be cut down and welded onto the post to achieve the correct measurements as described in the manual supplied with all Roger Technology equipment.

Please see the second video; part 2 on installing an M20 swing arm operator.

 

If you have any questions or require any assistance installing this type of motor please comment below.

← Next Post Previous Post →