Articles & Guides » video guides
In this video Mark explains how to set up and wire in a set of photocells for your automated electric gate system. Using a small screw driver Mark details how to securely wire in an external Cat 5 cable into the 24v photocell, providing power to the photocells. If you have any questions or require any assistance installing this type of motor please comment below.
In part 2 of the geometry setup for a Roger Technology M20 swing arm series operator; Mark discusses mounting the arm on the mounting brackets, which are securely mounted to the gate. Referencing measurements in the manual supplied enables you to establish where the second mounting bracket should be welded on and by placing the arm operator in the mounts you should be able to establish a good level in which to position the arm against the gate. If you have any questions or require any assistance installing this type of motor please comment below.
In this video Mark discusses geometry when installing a Roger Technology M20 series swing arm motor. All measurements when installing the M20 start from the gate pin in which the gate is hung, referencing the manual that is supplied with the M20 motor you will find all corresponding measurement as described in the video. The ram that the motor is mounted to is welded to the gatepost and measurements are calculated from this point. The motors mount and be cut down and welded onto the post to achieve the correct measurements as described in the manual supplied with all Roger...